Push rod material

Discuss the IOM class rules and interpretations

Moderators: Pedro Egea, jeffbyerley

Post Reply
maximo
Posts: 4
Joined: 08 Feb 2005, 00:22
Location: arg-322

Push rod material

Post by maximo » 30 Mar 2010, 03:07

Can I use a rudder Push-rod made of Carbon fiber?

Barry Fox CAN262
Posts: 354
Joined: 21 Apr 2007, 17:54
Sail number: CAN 46
Club: VMSS
Design: V8
Location: Vancouver Island, BC, Canada

Re: Push rod material

Post by Barry Fox CAN262 » 30 Mar 2010, 05:37

Somebody more knowledgeable than me will give the definitive answer but my understanding was that if it was a rod that was below deck and didn't have any effect on the water sealing then it was OK but if it is a push rod that comes from below deck up onto the deck, as would be the case on most skiff/scoop style rear decks, it would be penetrating the deck (this providing the water seal) and would not pass the test.

But that isn't official.
Barry Fox
CAN 46
Vancouver Island, BC, Canada

Lester
Posts: 611
Joined: 14 Oct 2004, 22:29
Location: GBR 105
Contact:

Re: Push rod material

Post by Lester » 30 Mar 2010, 08:56

IOM Class Rules wrote:D.2 HULL
D.2.1 MATERIALS
(a) Subject to (b) and (c), the hull, excluding fittings and remote control equipment but including any supports and containers for such items, shall be made of and joined using one or more of the following materials:
(1) metal,
(2) wood; wood based products containing only permitted materials,
(3) glass fibre reinforced plastic

D.2.3 FITTINGS
Fittings are unrestricted except that:
(a) Fittings that can contribute to the stiffness and/or strength and/or watertight integrity of the hull shall be of materials permitted by D.2.1.
Not sure that a c/f push-rod might contribute to 'watertight integrity', but an interesting idea. Perhaps Robert could offer an opinion that at this stage would be informal and unofficial ... (smile).
Lester Gilbert
http://www.onemetre.net/

Post Reply