Rough IOM A rig set up

Discuss IOM design, building an IOM, information on suppliers, tuning an IOM, results of recent events, etc

Moderator: Pedro Egea

Post Reply
geoffreythomson
Posts: 2
Joined: 24 Mar 2004, 15:58
Location: GBR1631

Rough IOM A rig set up

Post by geoffreythomson » 20 Jul 2004, 23:04

I have an Image that needs to go back into water after collision a couple of weeks ago needs a rough set up guide as all all settings lost have seen Lester G site sounds fine but how big is a finger Mine can vary from 1/2" to 1" for jib and main draught settings mm would be great if anyonyone has the very basic tune parameters
Thanks someoneone
G

cfwahl
Posts: 79
Joined: 23 Nov 2003, 23:01
Location: CAN 62

Post by cfwahl » 21 Jul 2004, 06:32

geoffreythompson wrote:
how big is a finger Mine can vary from 1/2" to 1" for jib and main draught settings
My "finger" is 12.7mm in heavier air, and swells to 25.4mm in light airs, but in the very lightest airs, especially if not too puffy, I might go back down to near 12.7mm.

Just pulling your chain; all this stuff is relative depending on a host of conditions, and one person's gospel is another's hoo-doo. Best to get local help, and lots of experience sailing head-to-head against similar boats, in other than regatta conditions (where winning is the focus, not tuning).
Charles Wahl

Post Reply